ACT ACT5 PROX Bedienungsanleitung PDF herunterladen (Seite 7)

ACT 5e prox Operating and Installation Manual Rev 1.0

Option Function Default Operation

30 Card or PIN On When set, a valid Card or valid PIN will open the door.

31 Card and PIN Off When set, only users with both a Card and PIN are admitted.

Cards are assigned to a particular user using the Adding Cards

function (function 5) and PINs are assigned using the Changing

PIN Codes function (function 0).

32 Card and any PIN Off In this mode, a valid card and any valid PIN code will open the

door. This mode allows all users to have a common PIN code to

use with their cards.

40 Permanent Backlight On When set, the keypad illumination is always on. This option will

override option 41 (Auto Backlighting).

41 Auto Backlighting Off When set, the keypad illumination is normally off, but will switch

on in response to any key being pressed, or when a card is

presented or while in programming mode. This option is

overridden by option 40 (Permanent Backlight). To prevent any

illumination, turn off options 40 and 41

Restoring Factory Defaults

Enter Programming Code followed by . This restores the ACT 5e prox to its default settings.

If the Programming Code has been forgotten, it may be set to 9999 by:

1. Remove the power from the unit.

2. Remove link LK1 at the back of the unit.

3. Apply power to unit.

4. Replace link LK1.

5. Programming Code is now set to 9999.

Note: The keypad will not operate correctly without LK1 in place.

Defaulting memory takes 3-4 seconds. During this time, the buzzer will sound an elongated tone.

- 7 -

1 2 3 4 5 6 7 8 9 10 11 12

Keine Kommentare

ACT ACT5 PROX Bedienungsanleitung Seite 7