ACT ACT5 PROX Bedienungsanleitung PDF herunterladen (Seite 2)

ACT 5e prox Operating and Installation Manual Rev 1.0

Installation Notes

• Remember to Factory Default the ACT 5e prox before programming.

• Remember to place the supplied varistor across the terminals of the door strike coil to protect

the relay contacts.

• Don’t mount the ACT 5e prox unit near RF sources (e.g. mobile phones, radio transmitters, etc)

or metal surfaces.

• Never use the on-board relay to switch AC mains voltage. An external relay, electrically

isolated from the ACT 5e prox, should be used for this purpose.

• Remember to change the programming code.

• When ordering new cards or fobs specify ACTRFID. (Note: ACT 5e prox will NOT work with

HID cards or fobs.)

Important

As with any Access Control system, always ensure there is an alternate means of escape in the

event of the unit failing to operate due to power loss or in the event of fire.

Product Specification

Number of Users 50 (50 PINs and 50 Cards)

Supply Voltage 12 - 24 V AC or DC (linear PSU)

Current Consumption 60mA (nominal), 100mA (maximum)

Operating Temperature -10 to +50 degrees C

Door Open Time 0 - 255 seconds

Relay Contact Rating 5A / 50Vac

Keypad Size Flush Mount: 100 x 110 x 20mm

Surface Mount: 128 x 94 x 18.5 mm

Keypad Weight 220 grams

Water Resistance High IP67

Construction Rugged Polycarbonate housing with stainless

steel keys and potted electronics.

Ordering Information

Product Product Code

Proximity card ACTProx ISO-B

Proximity fob ACTProx Fob-B

Proximity half shell card ACTProx HS-B

Proximity card with magnetic stripe ACTProx DUO-B

- 2 -

1 2 3 4 5 6 7 ... 11 12

Keine Kommentare

ACT ACT5 PROX Bedienungsanleitung Seite 2